Zeppelin Design Labs

Bypass Switch Not Working

Home Forums Quaverato Forum Quaverato FAQ & Support Bypass Switch Not Working

This topic contains 2 replies, has 3 voices, and was last updated by  zdlAdmin 2 months, 1 week ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #14634 Reply

    DavidDavid

    Hi Folks,
    Just finished by build and got to the point of Calibration & Setup step 3A (plugging it in) to find that the btpass switch is only working as a momentary switch, it doesn’t “latch”. I know the switch itself is momentary, but my understanding is that the microcontroller is programmed to toggle the bypass on and off. The red bypass LED only stays on while the switch is momentarily depressed, and during that time I get no sound through the output. Troubleshooting suggestions? Thanks!
    -David

    #14637 Reply

    brach
    Moderator

    Make sure that pin 11 on the microcontroller is being low (close to 0 volts) when the bypass mode is enabled. Also make sure that when momentary mode is enabled pin 11 goes high (close to 5 volts). Test this and let me know what you find.
    -Brach

    #14640 Reply

    zdlAdmin
    Keymaster

    Allow me to interject with a clarification. I believe my partner is referring here here to the toggle y labeled MOM / TOG. This toggle switch toggles the foot switch between Momentary and Toggle modes.
    Glen

Viewing 3 posts - 1 through 3 (of 3 total)
Reply To: Bypass Switch Not Working
Your information:




avant-garde audio & electronic products