Zeppelin Design Labs

How my build went

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #16530 Reply
    Terry
    Participant

    Build went great! I would alter some of the assembly instructions, but the main reason I joined this forum is because with a Radio Shack 9VDC 300mA wall wort I get a really bad AC hum. Using my bench power supply works great. Any ideas?

    Some things I would do different. Install the battery holder before the power switch. Screw down the battery holder then solder the wires.

    I used some scotch tape to hold some parts in place before I turned the board over to solder.

    Terry

    #16602 Reply
    brach
    Moderator

    I’m glad your build went well, but i’m sorry about the ac hum. If everything works well with your bench supply, then there must be an issue with your radio shack power supply. Try a different power supply or a battery to see how it goes. Possibly the filter cap(s) may be old/dried out in your ratio shack supply. You could check the ac ripple under load from your supply with your voltmeter.
    Thanks for the suggestions. We are currently in the process of designing the Macchiato MKII which will have several improved features. I”ll take your suggestions into consideration when we make the assembly manual for it.
    Thanks and good luck.
    -Brach

Viewing 2 posts - 1 through 2 (of 2 total)
Reply To: How my build went
Your information:




avant-garde audio & electronic products