Kit

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • February 7, 2020 at 3:13 pm in reply to: LFO and Bypass led #20373
    Kit
    Participant

    The new controller helped. However, the sound is very muddy. In calibration mode, only the LPF works but not the HPF. Also, the gain trim pot doesn’t change the volume. Rats.

    Kit

    January 20, 2020 at 7:19 pm in reply to: LFO and Bypass led #20002
    Kit
    Participant

    Continuity – bypass square pad to ground – power off and on.
    Continuity – round pad – only power on.

    January 20, 2020 at 6:20 pm in reply to: LFO and Bypass led #19999
    Kit
    Participant

    Disconnected the bypass at the lug and start up was good. Resoldered the lug and it worked as expected. Was able to calibrate the trim pots and solder the jumpers. Power up….. back to 2-4-2 even with bypass not connected.

    Ground issue somewhere.

    Kit

    January 20, 2020 at 9:38 am in reply to: LFO and Bypass led #19991
    Kit
    Participant

    Thanks, Glenn. I did reflow the joints but will try disconnecting the bypass switch tonight. The LFO is blinking 2-4-2.

    Kit

    January 18, 2020 at 4:03 pm in reply to: LFO and Bypass led #19923
    Kit
    Participant

    Pin 4 to ground is .001v, BTW.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)