Percolators with Beautiful and Unusual Finishes

[Glen v A]

Mike in Downstate Illinois sent us this photo of his FABULOUS two-tone stain job. You can read his complete comments in the User Reviews section. Note the stain job matches his guitar strap.

• This topic was modified 9 years, 7 months ago by Glen v A.
• This topic was modified 9 years, 7 months ago by Glen v A.
• This topic was modified 9 years, 7 months ago by Glen v A.
• This topic was modified 8 years, 9 months ago by zdlAdmin.
• This topic was modified 8 years, 9 months ago by zdlAdmin.
• This topic was modified 7 years, 11 months ago by zdlAdmin.

[zdlAdmin]

Ian Swanwick sent us this nice photo of a fantastic Percolator build. His construction notes follow:

“Thanks [Glen] for the compliments, it really did turn out well and your instructions were excellent.

“The finish is 3 coats of Minwax oil based stain ‘honey 272’ with sanding in between, followed by 2 coats of Minwax polyurethane fast drying ‘clear satin’. The polyurethane was left over from a few years ago and I don’t think I’d use it again – too hard to get an even finish.

“I plugged the screw holes on the sides and they are very hard to see with the stain. For the grill I substituted brass screws for the exposed heads as I think they look a little better.”

[Author]

Posts