Forum Replies Created
-
Posts
-
Hi Brach, thanks again for the comprehensive pics etc, very helpful. So I’ve cut the traces fine, and am just about to do the jumpers, the one from R4 to the pin on U2-TL074 is fine, but the one from C11 to C15 is a little more tricky, access to that solder joint on C15 is quite restricted by the cap itself on the component side of the board and by the ‘Harmonic Mix’ pot on the other side, I’d prefer if possible not to unsolder the pot. So I’m wondering if it’d be possible to run that jumper from C11 to C10 instead as there’s a direct trace between the required lead on C15 to C10 and that solder joint is far easier to reach. Electronically I can’t think why this wouldn’t work but I wanted to check, I may be misunderstanding it.
Many thanks
Ben
That’s so kind to provide that solution Brach, thanks. Do you know this mod would have any other knock-on effects?….alter the sound or functionality in any way?
Thanks
Ben
Hi Brach, thanks for your reply, that’s awesome news about the bypass CC messages, and I’d definitely like to install that if you’re able to send me the update. I’ll order the programmer from the dealer here in the UK.
And no worries about the exp pedal assignment update, I can do without that for the time being, it’s the bypass thing that was causing me issues! Do you need my email to send the software?
Many thanks
Ben
Thanks for that Brach, I solved it & am slightly embarrassed that I’d didn’t work out the problem before, but I did what you suggested and it does enter calibration mode fine, that wasn’t the issue. I realised that it was probably still in omni-channel mode, so I simply sent a CC#124 message on midi channel 2 and this has fixed it, it now responds perfectly on channel 2 alone! Now all I have to do is get it integrated in to my board and it’ll all be great! Thanks again for you attentive reply.
Ben
Hi all, has this bug been fixed? I’ve recently completed my Quaverato build and all the main controls work fine, everything checks out and it sounds amazing, however, it won’t set to a single midi channel (in my case I’m trying to set it to channel 2) whether I send a PC message or a CC message in calibration mode. Midi is working, I can see it change presets when I scroll through PC values on my controller, but it does this regardless of which channel I send it on. I have 3 midi pedals on my board and use midi to make them do different things at different times with PC, CC and expression control, so really do need to be able to isolate the Quaverato to only listen to a single channel or it’ll be sonic chaos…and not in a good way! Any tips for sorting this?
Thanks
