3D printable case for the Altura

Home Forums Altura Theremin MIDI Controller Forum Altura FAQ & Support 3D printable case for the Altura

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #32642 Reply
    jasonbirchler
    Participant

    Hi,

    Is anyone aware of a 3D-printable case for the Altura (MK I or II)? I was thinking of designing one, but no point if one already exists ๐Ÿ™‚

    thanks,
    jason

    #32643 Reply
    zdlAdmin
    Keymaster

    I thought there was one posted on the forum somewhere. I will check. If not, I’ll whip up a printable version off the stock case this afternoon.

    #32653 Reply
    zdlAdmin
    Keymaster

    Here we are! Sure enough, I made these a while ago and thought I posted them somewhere convenient. These are STL files of the Altura MKII cabinet, and lid. For the Cabinet model, I merged the individual kit components into a single mass, which you can print as one piece. It contains undercut features and will require some support structure. The thick end parts can be shelled internally and printed at lower interior density to save a little time, weight and material.

    The lid contains no undercut features if printed face-down.

    Be careful with units!! These models are either in decimal millimetres or decimal inches. The correct-size lid, for instance, is about 4″(100 mm) wide x 5″(125 mm).

    https://zeppelindesignlabs.com/wp-content/uploads/docs/AlturaMkII-Cabinet.STL
    https://zeppelindesignlabs.com/wp-content/uploads/docs/AlturaMkII-Lid.STL

Viewing 3 posts - 1 through 3 (of 3 total)
Reply To: 3D printable case for the Altura
Your information: