Just now getting to testing, been a busy week. However I have a whole new problem now. Plugged in the same power supply, which I thought was appropriate, 9V 1000mA. However the pedal wouldn’t even power on. The plug itself was very hot so I just tried a different supply: 9v 200mA. Pedal powers up, both tap tempo and bypass LEDs are functioning properly. However, now when the bypass switch is activated no signal comes through, regardless of the VOLUME position. I did still check for voltage in the spots given by the chart and everything tests fine except for the green points (9V) which are reading 12V. This is where my veeeerrrry basic knowledge ends so forgive me for not knowing what this means.