Home

[Christophe DUPONT]

Hello Brach,
I’m back on the pedal , I checked Q1, R14, VR8 and R8. I have nothing on R14 and R16 and also the depth. The high pot is not working and the led neither. I have damaged the PCB and I’m not able to use a tiny wire for any of the damaged jumpers. I don’t have the skills to solve the problems I think :/

I will try to ask someone to help me, I had fun nevertheless, I might order a new one.

Here a picture of the PCB.

View post on imgur.com

Chris

[Christophe DUPONT]

Thanks a lot for your reply, does a lugs from a diode can make it works? The LED is not working neither.

I spent the all afternoon working on it. I will take a break 😀

Cheers from France

[Christophe DUPONT]

EDIT : The bypass is working

[Christophe DUPONT]

So far I have been re-soldering the bypass. It happens to work just fine and then OPT01 led is not working I think my project is dead since the pub is all burn 🙁
I took off the optocoupler (opt01) and the bypass is not working anymore

here are the picture

View post on imgur.com

Is there a way to make it work or should I buy the kit again?

[Christophe DUPONT]

I’m at step 4 by the way, but I don’t really understand what I’m supposed to do. Sorry English is not my mother langage.

Thanks for all your help.

[Christophe DUPONT]

I can’t calibrate the high trim pot. There is no signal.
The jumpers are not soldered yet.

[Christophe DUPONT]

Hello, I tried but I don’t understand everything on the troubleshooting guide.

[Author]

Posts